Chevron Stitch Baby Blanket

The Chevron Baby Blanket is a simple yet effective pattern. We have knit the baby blanket in The Woven Smooth Merino, colours Mist and Frost. By using just two soft shades, we have created a more muted and minimal look. 
The Chevron Baby Blanket is a wonderful pattern for adventurous beginners as it  is a simple combination of knit, purl,  increasing and decreasing.
We have put together some more colour combinations below:
Smooth Merino in Blossom and Mist

Heavy Merino in Hunter’s Green and Dusty Artichoke

Heavy Merino in Deep Petroleum Blue and Dusty Petroleum Blue  

Heavy Merino in Oat and Rose Clay 

Heavy Merino in Oat and Plum Clay 
Heavy Merino In Terracotta Rose and Rose Clay
Heavy Merino in Pearl Gray and Dusty Petroleum Blue

What you need:
The Woven Smooth Merino: 200g Colour A, 200g Colour B
Knitting for Olive Heavy Merino: 150g Colour A, 150g Colour B
5mm needles
Finished Dimensions: 55cmx80cm

With Colour A and 5mm needles, cast on 121 stitches.

Row 1(RS): k1, ssk, k9, yo, (k1, yo, k10, dbl dec, k10, yo) repeat to last 13 stitches, k1, yo, k9, k2tog, k1.

Row 2(WS): Purl to end of row, making sure you purl the yo stitches tbl.

Repeat Rows 1 & 2, 5 times  (10 rows in total) then change to Colour B. Repeat Rows 1 & 2 in Colour B 5 times (10 rows in total). Continue in this pattern, changing colours every 10 rows, until there are 8 sections in Colour B, and 9 sections in Colour A (you will end on Colour A).
Cast off knitwise on the next RS row.
Finishing: Weave in ends, and block to dimensions specified.
k - knit
p - purl
ssk - slip next stitch knitwise to right needle, then slip this same stitch back purlwise to left needle. Then k2tog tbl.
k2tog - knit the next two stitches together.
k2tog tbl - knit the next two stitches together through the back loops.
dbl dec - double decrease:slip next two stitches together knitwise, k1, then pass two slipped stitches over ( two stitches have been decreased).
yo - yarn over (increases 1 stitch)
RS - right side
WS - wrong side

Leave a comment

Please note, comments must be approved before they are published